Well, getting blinking red LED on your Linksys Velop tri-band device it isn’t in reach of your node and existing device (modem). So, to get it fixed, first you have to unplug your Linksys Velop tri-band device and take it where your primary node and your existing modem is placed.
And, once you are done with the placement process, you can execute the power cycling or restarting process.
Power Cycle Linksys Velop Tri-band Router
Here’s how to do so:
Step 1: You have unplugged your Linksys Velop tri-band device, right? Keep it unplugged. Are you sure that the wall socket you are about to choose for your Linksys Velop tri-band device for plugging it in is near to your modem and the primary node? If yes, then it’s ok. Else, you can make use of the extension to make things working.
Apart from this, if you don’t want to put your Linksys Velop tri-band device into clutter of messy wires, then you can build 2-3 new wall sockets for them at the same place.
Step 2: So, all of them are finally placed within reach of each other, aren’t they? If you nod in yes, then without much delay, plug in your Linksys Velop tri-band device back again.
Step 3: The power LED on your Linksys Velop tri-band device will start blinking in blue color. It indicates that your device has finishing power up.
So, can we hope that the restarting process has fixed the blinking red LED issue for you? If you said yes, then it would be a big relief for us.
One more thing we would like to tell you! Look, blinking red LED issue on your Linksys Velop tri-band device can be easily fixed by simply power cycling. But, what if you continuously get a stable LED on it instead of blinking?
Contact Your Service Provider
Need not to worry! Stable red LED on your Linksys Velop tri-band device means that you have no internet (online connection) and you have to check with your internet service provider for interruptions.
Just make sure to upgrade your existing data plan and clear all the pending internet bills.
Just in case, you find that everything is sorted out from your ISP’s end and you are getting the same issue all over again and again, then the only way to get a relevant fix to the issue is to reset your Linksys Velop tri-band device back to the factory default settings. Doing so will surely fix the issue for you. Apart from this, the resetting process will make your Linksys Velop tri-band device brand new as well.
So, without much ado, take the plunge to reset your Linksys Velop tri-band device.
Reset Linksys Velop tri-band Router
1 Step: First, you need to keep your Linksys Velop tri-band device away from your existing modem and your primary node. Yes, for this, you have to unplug it and take it away from them. This process is just temporary.
2 Step: Now, plug in your Linksys Velop tri-band device again.
3 Step: Press the reset hole on your Linksys AX4200 device and hold it for several minutes.
4 Step: Release it and your Linksys AX4200 device will be reset.
What? Resetting is not enough! Here comes the final step! Reconfiguration of your Linksys AX4200 device! Yes, after the reset of the device, you have to perform the Linksys Velop AX4200 setup process again.
In a Nutshell
Resetting Linksys AX4200 device has helped millions of users across the globe to fix blinking or stable red light issue. Do not jump on the reset process! It is the last step! First, try power cycling your Linksys AX4200 device and then contact your ISP. If you find that the things are going out of your hand, then give the reset process a try.
